Datasheet

33
UPS AC power
UPS
UPS
WiFi Router
Switch
Turbo NAS (UPS Master)
Wi-Fi Router
Turbo NAS (UPS Slave) Turbo NAS (UPS Slave)
AC mains
UPS support
USB signal
detection
USB signal
detection
UPS AC powerUPS AC power
AC mains
AC mains
UPS supporting
SNMP
Ethernet
Ethernet Ethernet
UPS AC powerUPS AC powerUPS AC power
UPS AC power UPS AC power
UPS AC power
UPS AC power
Low power shutdown signal
UPS AC power
UPS
UPS
WiFi Router
Switch
Turbo NAS (UPS Master)
Wi-Fi Router
Turbo NAS (UPS Slave) Turbo NAS (UPS Slave)
AC mains
UPS support
USB signal
detection
USB signal
detection
UPS AC powerUPS AC power
AC mains
AC mains
UPS supporting
SNMP
Ethernet
Ethernet Ethernet
UPS AC powerUPS AC powerUPS AC power
UPS AC power UPS AC power
UPS AC power
UPS AC power
Low power shutdown signal
Uninterruptible Power Supply (UPS)
In the event of a power failure the Turbo NAS will shut down automatically or enter auto-protection mode by probing the
power status of the connected UPS unit. You can set up this function by clicking QTS [Control Panel] > [System Settings] >
[External Device] > [UPS].
Case study for NAS connecting to a USB UPS
You can set the Turbo NAS to shut down or enter auto-protection mode if the power fails, and determine the action to
take after few minutes of power failure. Once the auto-protection mode is activated, the Turbo NAS will revert to the state
before power failure and continue to operate when the power restores.
UPS with SNMP management
When the Turbo NAS and the SNMP-based UPS server connect to the same network, you can select [SNMP connection]
and enter the IP address of SNMP UPS server to set up power failure notication.
QTS 4.1 OS