User Manual

107
interface will be shown. Click the "Edit" button to edit the settings:
IPv 6 Auto C o nfigura tion: If an IPv6 enabled router is available on the network,
select this option to allow the NAS to acquire the IPv6 address and the
configurations automatically.
Us e sta tic IP a ddre s s : To use a static IP address, enter the IP address (e.g.
2001:bc95:1234:5678), prefix length (e.g. 64), and the gateway address for the
NAS. You may contact your ISP for the information of the prefix and the prefix
length.
o
Enable Router Advertisement Daemon (radvd): To configure the NAS as an IPv6
host and distribute IPv6 addresses to the local clients which support IPv6,
enable this option and enter the prefix and prefix length.
IPv 6 DNS s e rv e r: Enter the preferred DNS server in the upper field and the
alternate DNS server in the lower field. Contact the ISP or network administrator for
the information. If IPv6 auto configuration is selected, leave the fields as "::".
Se rv ic e B inding
The NAS services run on all available network interfaces by default. To bind the services
to one or more specific network interfaces (wired or wireless), enable service binding.
The available network interfaces on the NAS will be shown. All the NAS services run on
all network interfaces by default. Select at least one network interface that each service
should be bound to. Then click "Apply". The users will only be able to connect to the
services via the specified network interface(s). If the settings cannot be applied, click
"Refresh" to list the current network interfaces on the NAS and configure service binding
again.
Note :
The service binding feature is only available for the NAS with more than one
network interfaces (wired and wireless).
After applying the service binding settings, the connection of the currently online
users will be kept even if they were not connecting to the services via the
specified network interface(s). The specified network interface(s) will be used for
the next connected session.
Prox y
Enter the proxy server settings to allow the NAS to access the Internet through a proxy