User manual

Chapter 3. Start to Use the VioStor

When you have installed the VioStor and other hardware, and connected it to the

network, you can use the browser in your PC to connect to the VioStor. It is

recommended to use Microsoft Internet Explorer 6.0 for browsing.

Important Notice:

Before you start to use the VioStor, you must install the hard disks in the VioStor,

finish disk volume configuration and format the hard disk(s). Otherwise, the

system may not function properly.

3.1 Connect to the VioStor

Follow the steps below to connect to the VioStor monitoring page:

1. Open an IE browser and enter the IP address of the VioStor or run Finder.

When the following screen is shown, double click the name of the VioStor.

Double click

VioStor name to