Owner manual

171
Advanced Mode:
The advanced mode consists of the event and action sections. Define the action to take for
each event triggered on the IP cameras or the video servers connected to the NVR.
To configure the advanced event management by the ‘Advanced Mode’, select an event
type on the left channel list and configure the actions to take on the right.
Note:
 Click ‘Apply’ to apply the settings or ‘Exit’ to exit the settings page. If the ‘Advanced
Mode’ is selected on the ‘Alarm Settings’ page, the advanced settings will be applied
after the NVR restarts even if you have selected to exit the settings page. The settings
will be cancelled if ‘Traditional Mode’ is selected after exiting the ‘Advanced Mode’.
 To avoid blocking by the firewall, the IP cameras or the video servers configured for the
alarm recording must be located on the same subnet as the NVR.
 To switch from the advanced mode to the traditional mode, select ‘Traditional Mode’
and click ‘Apply’.