User`s guide

Introduction
VMS Interface for QMS Crown Printers3-2
Introduction
This chapter takes you step-by-step through the installation of the
QMS host software for host-, LAT-, or serial/parallel-connected print-
ers.
Before You Begin
Before installing the host software, ensure that the designated system
port is identified and properly configured for the target printer port to
be used.
If This is an Update
If you’re updating your host software from a previous version and you
want to save predefined set-up files, move them from the old device
control library at this time. To do this, use the following commands:
$ library/extract=module_name -$ _$
SYS$LIBRARY:QMS$DEVCTL20.TLB -
_$/OUT=module_name.tmp
A Device Control Library update utility has been provided in the
sys$common:[sysmgr] directory. To run this procedure, type:
$ @sys$common:[sysexe]qms$update_lib
» Note:
This procedure provides a user-friendly method of copying
library modules from one Device Control Library to another. Additional
information is displayed when this procedure is run.