User`s guide

Installing the
DECnet Host
Software
VMS Interface for QMS Crown Printers2-18
Naming the Queues
The installation continues for both Phase IV and Phase V software
with the following steps to name the execution queue.
1 You’re next prompted for the name of the execution queue.
» Note:
If this is a system update and the target queue exists, then
that queue must be stopped and deleted from the active system.
* Enter a name for the QMS printer's execution
queue [QMS_
nodename ]:
Enter the name of the execution queue associated with the QMS
printer you’re updating. If this queue name exists, the program
displays the following prompt:
* The execution queue
queue_name exists, replace
it [YES]?
Typ e N to keep the existing queue name.
2 If a queue start-up file exists, the program displays the
prompt:
* An existing queue start-up file was found,
replace it [YES]?
Type N to append new queue to the existing queue start-up file.
Ty pe Y to install a new version of the QMS$START_-QUEUE.COM
file. Your existing start-up file is renamed to
QMS$START_QUEUE.OLD.