User`s guide

'(&7(.0RGHV
/13OXV(PXODWLRQIRU4063ULQWHUV
All characters in Incremental Plot Mode must be uppercase.
%\SDVV0RGH
In Bypass Mode, the printer receives data but does not print or
change the current position. You enter Bypass Mode from any other
mode by sending the <ESC><CAN> command. To exit Bypass Mode,
use any one of the following commands:
<ESC><CR>
<ESC><LF>
<ESC><FF>
<ESC><US>
<BEL>
<CR>
<LF>
<US>
<BEL>
6ZLWFKLQJ0RGHV
The following figure illustrates the commands you can use to switch
modes in DECTEK emulation.
E Up right (northeast)
A Right (east)
I Down right (southeast)
H Down (south)
J Down left (southwest)
B Left (west)
F Up left (northwest)