User`s guide

'(&7(.0RGHV
/13OXV(PXODWLRQIRU4063ULQWHUV
If you are printing in two columns, a <CR><LF> at the bottom of col-
umn 1 moves the current print position to the left margin of column 2
(an imaginary line in the middle of the Tekpage) at the top line. To
continue two column printing on the next page, you must issue an
<ESC><FF> in the last line of text in column 2 before the text auto-
matically wraps back to column 1.
*UDSK0RGH
DECTEK Graph Mode is the vector plotting mode. You can enter
Graph Mode from Alpha Mode (only) by issuing the <GS> or
<ESC><FS> command.
In Graph Mode, the first byte that the printer receives after the <GS>
defines the starting point of the vector. The second and successive
bytes define the endpoints of the vectors. For example, the following
sequence plots vectors to points B, C, and D beginning at point A.
<GS>ABCD
<GS>AB<GS>CD
You may select from a variety of vector styles using any of the follow-
ing escape sequences after the <GS> command:
<ESC>`
Normal intensity, solid vectors (` = hex 60)
<ESC>a
Normal intensity, dotted vectors
<ESC>b
Normal intensity, dot-dash vectors
<ESC>c
Normal intensity, short dash vectors
<ESC>d
Normal intensity, long dash vectors
<ESC>e
Normal intensity, solid vectors
<ESC>f
Normal intensity, solid vectors
<ESC>g
Normal intensity, solid vectors
<ESC>h
Bold, solid vectors
<ESC>i
Bold, dotted vectors
<ESC>j
Bold, dot-dash vectors
<ESC>k
Bold, short dash vectors