User`s guide

'(&7(.0RGHV
/13OXV(PXODWLRQIRU4063ULQWHUV
'(&7(.0RGHV
$OSKD0RGH
The DECTEK Alpha Mode is the default mode. Whenever the printer
receives the DECTEK escape sequence, it enables Alpha Mode. You
may enter Alpha Mode from any of the other modes by using any one
of these commands:
<US>
Switches to Alpha Mode from any mode and
clears Bypass Mode.
<ESC><BEL>
Same as <BEL>.
<ESC><BS>
Same as <BS>.
<ESC><HT>
Same as <HT>.
<ESC><LF>
Embeds a line feed in the file when followed
by a “no-op” code, such as <ACK>.
<ESC><CR>
Embeds a carriage return in the file when
followed by a “no-op” code such as <ACK>.
<ESC><VT>
Same as <VT>.
<ESC><FF>
Switches to Alpha Mode from any mode,
moves the current position to the home
position of the Tekpage and sets the current
left margin to Margin-1, clears EGM, ejects
the current page, and clears Bypass Mode.
Also resets vector pattern and width
(including transparent vectors) to the default
settings.
<ESC><FS>
Same as <FS>.
<ESC><GS>
Same as <GS>.
<ESC><RS>
Same as <RS>.
<ESC><CAN>
Switches to Bypass Mode.
<ESC><SUB>
Switches to Alpha Mode from any mode.
<ESC><US>
Same as <US>.