User`s guide

8VLQJWKH
'(&7(.
(PXODWLRQ
'(&7(.(PXODWLRQ
<ESC>[?38h
The printer makes these preparations for Tektronix emulation after
receiving the DECTEK sequence:
 If the printer's page buffer contains any data, the printer performs
a form feed. If the buffer is empty, the printer does not perform a
form feed.
 The printer saves the current state of ANSI mode (non-DECTEK
mode). The printer will restore this state after exiting DECTEK
emulation.
 The printer establishes the DECTEK mode “page” and selects
DECTEK fonts.
 The printer resets to their defaults any DECTEK modes that may
have been previously changed.
([LWLQJ'(&7(.(PXODWLRQ
To leave DECTEK emulation, use one of the following escape
sequences:
<ESC>[?38l
<ESC>[!p Soft Terminal Reset (DECSTR)
The DECSTR command also resets the printer to its power-up state.
For more information, see DECSTR, in chapter 3, “Printer Status and
Reset Commands.” Do not use the RIS (Reset to Initial State) escape
sequence (<ESC>c) to exit DECTEK emulation. During DECTEK
emulation, the printer interprets the RIS escape sequence as a valid
DECTEK command.