User`s guide

8VLQJWKH
'(&7(.
(PXODWLRQ
/13OXV(PXODWLRQIRU4063ULQWHUV
8VLQ
J
WKH'(&7(.(PXODWLRQ
Your QMS printer emulates the Tektronix 4010/4014 mode (DECTEK)
of the DEC LN03 Plus printer. In DECTEK, the printer processes text
or graphics data (vectors or plot data) as would a DEC LN03 Plus
printer.
You can use DECTEK to mix ANSI text with Tektronix graphics on the
same page as long as DECTEK occurs before any ANSI text has
been printed on the page.
When in DECTEK emulation, the printer plots data within a “Tekpage”
that is 3072 pixels wide by 2304 pixels and always in landscape orien-
tation (see the following figure). The Tekpage always keeps these
dimensions regardless of the physical page dimensions. The Tekpage
is slightly smaller than letter-size paper. If you use A4-size paper, the
Tekpage leaves a large right margin.
DECTEK emulation has five individual modes: Alpha Mode, Graph
Mode, Point Plot Mode, Incremental Plot Mode, and Bypass Mode
(See “DECTEK Modes” on page 8-6).
(QWHULQJ'(&7(.(PXODWLRQ
To enter DECTEK emulation, use the following escape sequence:
/HWWHU6L]H3DJ H $6L]H3DJH

S
L[HOV
SL[HOV

S
L[HOV
SL[HOV