User`s guide

6HOHFWLQJ
&KDUDFWHU6HWV
)RQW+DQGOLQJ
These designations remain in effect until you issue new designations
or mappings.
*UDSKLF6L]H6HOHFWLRQ*66
Use this sequence to set the character height of characters in the font
selected after this sequence.
Syntax: <ESC>P Pn <SP>C
The height of the characters implies the width of characters in the
font. The default value of Pn is 100.
For example, the following sequence selects an 8pt font:
<ESC>P80<SP>C
If an 8pt font has not been downloaded to the printer, the next greater
size font will be selected.
*UDSKLF6L]H0RGLILFDWLRQ*60
Use this sequence to select a new character size expressed as a
percentage of the size selected by the previous GSS command in
the current font.
<SI> Maps the ASCII character set (G0) to the GL table.
This is the default setup for the printer.
<SO> Maps the ASCII character set (G1) to the GR table.
This is the default setup for the printer.
<ESC>} Maps the Supplemental character set (G2) to the GR
table. This is the default setup for the printer.
<ESC>| Maps the Finnish character set (G3) to the GR table.
Pn Numeric value, expressed in units determined by
PUM and SSU, for the desired height of the
characters.