User`s guide

6HOHFWLQJ

&KDUDFWHU6HWV

/13OXV(PXODWLRQIRU4063ULQWHUV

After designating a character set as G0, G1, G2, or G3, map it to

either the “graphics left” (GL) table or the “graphics right” (GR) table.

The GL table corresponds to character values between Hex 00 and

Hex 7F. The GR table corresponds to character values from Hex 80 to

Hex FF.

See appendix B, “Character Sets,” for complete information on the

character sets and GL/GR tables. The following series of commands

illustrate how the graphics character set selection sequences could

be used:

Spanish

Swedish

Swiss

ISO Norwegian/Danish (value is hex 60)

<SI>

(Hex 0F) Maps G0 to GL

<SO>

(Hex 0E) Maps G1 to GL

<ESC>~

Maps G1 to GR

<ESC>n

Maps G2 to GL

<ESC>}

Maps G2 to GR

<ESC>o

Maps G3 to GL

<ESC>|

Maps G3 to GR

<ESC>N

Maps G2 to GL for one character

<ESC>O

Maps G3 to GL for one character

<ESC>(B

<ESC>)B

Designates the ASCII character set as both G0 and

G1. This is the default setup for the printer.

<ESC>*<

Designates the Supplemental character set as G2.

This is also the default setup for the printer.

<ESC>+5

Designates the Finnish character set as G3.