User`s guide

6HWWLQJ3DJH
)RUPDW
3DJH)RUPDWWLQJDQG3ULQWLQJ&RPPDQGV
 If the value of Pn
2
is omitted or set to 0, the right margin does not
change.
 If the value of Pn
1
is greater than the value of Pn
2
, the printer
ignores the sequence.
 If the value of Pn
2
exceeds the printable width of the page, the
right edge of the printable area becomes the new right margin.
If the current active position is left of the new left margin, the active
position moves to the left margin. If the current active position is right
of the new right margin, the next character printed generates a car-
riage return/line feed.
If the unit of measure is decipoints, the following sequence sets a left
margin of 1"/25.4 mm and a right margin of 0.5"/12.7 mm:
<ESC>[720;360s
+RUL]RQWDO3RVLWLRQ$EVROXWH+3$
Use this sequence to move the current position on the current line.
Syntax: <ESC>[ Pn ` (` = hex 60)
The HPA position cannot exceed the right margin.
+RUL]RQWDO3RVLWLRQ5HODWLYH+35
Use this sequence to move on the current line relative to the current
position.
Syntax: <ESC>[ Pn a
Pn A numeric value for the new position expressed in
units determined by PUM and SSU settings. The
value for
Pn is measured from the left margin. The
default value of
Pn is 1.
Pn A numeric value, expressed in units determined by
PUM and SSU settings, to add to the current position.
The default value of
Pn is 1.