User`s guide

6HWWLQJ3DJH
)RUPDW
/13OXV(PXODWLRQIRU4063ULQWHUV
 If the value of Pn
2
is omitted or set to 0, the bottom margin does
not change.
 If the value of Pn
1
is greater than the value of Pn
2
, the printer
ignores the sequence.
 If the value of Pn
2
exceeds the overall form length, the bottom of
the form becomes the new bottom margin.
If the current active position is above the new top margin, the active
position moves to the top margin. If the current active position is
below the new bottom margin, the next character printed generates a
form feed.
Whenever form length changes, the printer clears the top and bottom
margins, sets the top margin to 1, and sets the bottom margin to the
bottom of the new form length.
If the unit of measure is decipoints, the following sequence sets both
top and bottom margins to 1"/25.4 mm:
<ESC>[720;720r
6HW/HIWDQG5LJKW0DUJLQV'(&6/50
This sequence sets the left and right margins. The left margin is the
line home position. The printer cannot print text on the current page
outside these margins. (It can, however, draw vectors outside the
margins.)
Syntax: <ESC>[ Pn
1
; Pn
2
s
The new margins take effect as soon as they are received by the
printer with the following exceptions:
 If the value of Pn
1
is omitted or set to 0, the left margin does not
change.
Pn
1
Numeric value for left margin expressed in unit of
measure determined by PUM and SSU.
Pn
2
Numeric value for left margin expressed in unit of
measure determined by PUM and SSU.