User`s guide

6HWWLQJ/LQH
DQG&KDUDFWHU
6SDFLQJ
/13OXV(PXODWLRQIRU4063ULQWHUV
6HWWLQ
J
/LQHDQG&KDUDFWHU
6SDFLQ
J
6SDFLQJ3LWFK,QFUHPHQW63,
This sequence defines the number of units in a vertical or horizontal
increment. The values for Pn
1
and Pn
2
are expressed in either deci-
points or pixels depending on the setting of the SSU.
Syntax: <ESC>[ Pn
1
; Pn
2
<SP>G
Pn
1
and Pn
2
must be integers greater than zero. If either value is
zero, the printer uses the respective spacing increment built into the
current font. For example, the following sequence sets the line height
to 120 decipoints (6 lines per inch) and character width to the spacing
of the current font:
<ESC>[120;0<SP>G
6HOHFW9HUWLFDO/LQH6SDFLQJ696
Use this sequence to select a specific line spacing value.
Syntax: <ESC>[ Ps <SP>L
Pn
1
Value of the vertical spacing increment (line height) in
the unit of measure defined by SSU.
Pn
2
Value of the horizontal spacing increment (space
width) in the unit of measure defined by SSU.
Ps =
0 (default) 6 lines per inch (lpi),1 line = 1/6"
1 4 lines per inch (lpi),1 line = 1/4"
2 3 lines per inch (lpi),1 line = 1/3"
3 12 lines per inch (lpi),1 line = 1/12"
4 8 lines per inch (lpi),1 line = 1/8"