User`s guide
$ERXW3ULQWHU
6WDWXVDQG
5HVHW
&RPPDQGV
/13OXV(PXODWLRQIRU4063ULQWHUV
$ERXW3ULQWHU6WDWXVDQG
5HVHW&RPPDQGV
In LN03 Plus Emulation, your printer must be able to respond to que-
ries from the host. The host requests device attributes from the
printer. The printer responds with status reports.
▲ Caution:
In order to respond successfully to the host, the printer and
host must be connected via the serial port. If you do not use serial
communications, you may experience undesirable results if your
application uses the Product Identification or Cursor Position Report
sequences.
3ULQWHU6WDWXV&RPPDQGV
3URGXFW,GHQWLILFDWLRQ'$
The host computer can request that the printer identify itself. The
identification that the printer returns to the host depends on the con-
trol panel setting. Depending on your application and the printers it
supports, you may set Product ID to the LN03 Plus printer, the LQP02
printer, or the LA100 printer. Refer to chapter 2, “Emulation Configu-
ration” for information on how to set Product ID.
The host may request Device Attributes (DA) from the printer using
either of the following sequences:
<ESC>[c
<ESC>[0c