User`s guide
&KDQJLQJWKH
&RQILJXUDWLRQ
/13OXV(PXODWLRQIRU4063ULQWHUV
&KDQ
J
LQ
J
WKH&RQIL
J
XUDWLRQ
You can change your LN03 Plus Emulation configuration by selecting
new configuration option settings through your printer’s control panel,
through QMS Document Option Commands (DOC), or through the
PostScript configcartemulation operator. Refer to “Configuration
Options” on page 2-3 for descriptions of the configuration options.
Control panel selections
This is the most convenient way to change configuration settings.
Refer to the printer user's guide and/or setup manual for instruc-
tions on using the control panel to change configuration settings.
Configuration changes made through the control panel are in
effect from job-to-job unless overridden with the PostScript con-
figcartemulation operator or with QMS Document Option Com-
mands.
QMS Document Option Commands (DOC)
LN03 Plus configuration options can be selected through QMS
Document Option Commands. Configuration changes made with
DOC are in effect only for that job. After the print job is completed,
the printer automatically resets to the default configuration. Refer
to the
QMS Document Option Commands
manual for information
about using DOC and complete descriptions of the commands
and their parameters.
PostScript configcartemulation operator
Refer to “Using configcartemulation” on page 2-6 for information
on using this PostScript operator to change emulation configura-
tion settings. Configuration changes made through the PostScript
configcartemulation operator are the same as making configu-
ration changes through the printer’s control panel and are in
effect from job-to-job unless overridden with QMS Document
Option Commands.