User`s guide
'HLQVWDOOLQJWKH
406/13OXV
(PXODWLRQ
,QVWDOODWLRQ
5 If your printer has an Administration/Emulations/PostScript/
Emulation Level menu, set it to Level 2.
6 Make sure your printer is on line, and that the printer’s mes-
sage window reads IDLE.
7 Open an ftp session from your PC or workstation by typing
one of the following commands:
ftp
printername
↵ (for example, ftp pctdev6↵)
ftp
ipaddress
↵ (for example, ftp 161.33.130.45↵)
8 When prompted for a user name and password, press the
Enter key.
If your entries are correct, an ftp> prompt displays.
9 At the ftp> prompt, change to binary mode by typing
bin↵
10 At the ftp> prompt, send the deinstallation file to the
printer’s hard disk by typing
put ln03-del.ps↵
The ftp> prompt returns when the deinstallation file has finished
loading.
On most new QMS printers (for example: a QMS 2060, 2425, or
4060),
a page is printed with a message stating that the LN03
emulation was removed.
11 At the ftp> prompt, end the ftp session by typing
quit↵
12 When the Disk light stops flashing and the printer’s message
window reads Idle, restart the printer if it doesn’t automati-
cally restart.
»Note:
Some QMS printers automatically restart themselves at
this point.
The LN03 Plus Emulation is now no longer listed in the Options
section of the printer’s start-up page, in the Administration/Emula-
tion section of the printer’s configuration menu, and on the