User`s guide
,QVWDOOLQJWKH
406/13OXV
(PXODWLRQ
,QVWDOODWLRQ
2 Make sure your printer is on line, and that the printer’s mes-
sage window reads IDLE.
3 If you’re downloading the emulation from a UNIX worksta-
tion, copy LN03.PS from your PC to a temporary directory on
your workstation.
4 Open an ftp session from your PC or workstation by typing
one of the following commands:
ftp
printername
↵ (for example, ftp pctdev6↵)
ftp
ipaddress
↵ (for example, ftp 161.33.130.45↵)
5 When prompted for a user name and password, press the
Enter key.
If your entries are correct, an ftp> prompt displays.
6 At the ftp> prompt, change to binary mode by typing
bin↵
7 At the ftp> prompt, send the emulation file to the printer’s
hard disk by typing
put
ln03
.ps↵
The printer’s message window reads 1 Active Job, and the
Disk light flashes to indicate that the emulation is being down-
loaded to the hard disk. The ftp> prompt returns when the emu-
lation has finished loading.
8 When the download is complete, at the ftp> prompt, end the
ftp session by typing
quit↵
9 When the Disk light stops flashing and the printer’s message
window reads Idle for at least 30 seconds, restart the
printer.
10 When the printer’s message window reads Idle again, the
LN03 Plus Emulation is ready to use.
The LN03 Plus Emulation is now listed in the Options section of
the printer’s start-up page, in the Administration/Emulation sec-