User`s guide

,QVWDOOLQJWKH
406/13OXV
(PXODWLRQ
/13OXV(PXODWLRQIRU4063ULQWHUV
The LN03 Plus Emulation is now listed in the Options section of
the printer’s start-up page, in the Administration/Emulation sec-
tion of the printer’s configuration menu, and on the advanced sta-
tus page. On some older QMS printers, emulations are not listed
on the printer’s start-up page.
4 Increase the printer’s K Mem Emulation client (Administra-
tion/Memory/K Mem Emulation) by at least 1 MB or, for opti-
mum performance, by 2 MB.
See your printer documentation for more information on this
memory client and on using your printer’s configuration menu.
5 The LN03 Plus Emulation is ready to receive data from your
host. Now, you can custom configure your LN03 Plus Emula-
tion to match your printing environment. See chapter 2
“Emulation Configuration”.
»Note: You may want to erase any installation files left on your PC
and then remove any temporary directories.
,QVWDOODWLRQYLDDQ(WKHUQHW1HWZRUN
&RQQHFWLRQ
This procedure is used to install the QMS LN03 Plus Emulation to
printers over an Ethernet network. If you want to install the emulation
via a parallel or serial port, refer to “Installation via a Parallel or Serial
Port” on page 1-7.
»Note: Before you begin this procedure, your printer and your PC (or
UNIX workstation) must be connected to an Ethernet network running
TCP/IP and have valid IP addresses.
»Note: This procedure assumes that LN03.PS has been unzipped
from LN03.ZIP and resides in a temporary directory on your PC’s
hard disk. For the unzipping procedure, refer to “Unzipping the LN03
Plus Emulation File” on page 1-6.
1 If your printer has an Administration/Emulations/PostScript/
Emulation Level menu, set it to Level 2.