User`s guide
,QVWDOOLQJWKH
406/13OXV
(PXODWLRQ
,QVWDOODWLRQ
4 At the DOS prompt, enter the following command to unzip
LN03.ZIP.
pkunzip ln03.zip↵
5 Confirm that LN03.PS is now in the temporary subdirectory.
6 Remove the LN03 Plus Emulation diskette from your PC’s
disk drive, and store it in a safe place.
,QVWDOODWLRQYLDD3DUDOOHORU6HULDO3RUW
This procedure is used to install the LN03 Plus Emulation to printers
via a parallel or serial port. If you want to install this emulation over a
network, refer to “Installation via an Ethernet Network Connection” on
page 1-8.
»Note:
This procedure assumes that LN03.PS has been unzipped
from LN03.ZIP and resides in a temporary directory on your PC’s
hard disk. For the unzipping procedure, refer to “Unzipping the LN03
Plus Emulation File” on page 1-6.
1 If your printer has an Administration/Emulations/PostScript/
Emulation Level menu, set it to Level 2.
2 Download the LN03 Plus Emulation to the printer.
a With your computer at the DOS prompt and at the temporary
subdirectory, enter one of the following commands as
appropriate:
For a parallel connection:
copy /b ln03.ps lpt#↵
where # is the port number (1 to 3).
For a serial connection:
copy /b ln03.ps com#↵
where # is the port number (1 to 4).
3 When the download is complete, restart the printer.