User`s guide

,QVWDOOLQJWKH
406/13OXV
(PXODWLRQ
/13OXV(PXODWLRQIRU4063ULQWHUV
,QVWDOOLQ
J
WKH 406/13OXV
(PXODWLRQ
These procedures are used to install the QMS LN03 Plus Emulation
to QMS printers. Since this emulation is stored on a hard disk, your
printer must have either an internal or external hard disk.
7KH/13OXV(PXODWLRQ'LVNHWWH
The LN03 Plus Emulation Diskette contains the following files:
 PKUNZIP.EXE
 LN03.ZIP (contains LN03.PS)
 LN03-DEL.PS
LN03.PS contains the LN03 Plus Emulation. To install the emulation,
this file is sent to the printer using the installation procedures pre-
sented later in this chapter.
LN03-DEL.PS is the deinstallation file. To deinstall the emulation, this
file is sent to the printer using the deinstallation procedures presented
later in this chapter.
To obtain LN03.PS, PKUNZIP.EXE is used to unzip LN03.ZIP. When
unzipped, LN03.PS consumes almost 1.8 MB. LN03.PS was zipped
to fit on one diskette.
8Q]LSSLQJWKH/13OXV(PXODWLRQ)LOH
Before you install the LN03 Plus Emulation to your printer, you must
first obtain LN03.PS from LN03.ZIP. Do this as follows:
1 Insert the LN03 Plus Emulation diskette into your PC’s 3.5"
disk drive.
2 Either in Windows or DOS, create a temporary subdirectory
on your PC’s hard disk and copy PKUNZIP.EXE and LN03.ZIP
into the subdirectory.
3 In DOS, change to the temporary subdirectory.