Setup guide

+%!&
,-.&
"
($
1 Use the Administration/Memory/Enable Disk Swap menu to enable disk
swapping.
Disk swapping takes full advantage of the disk by allowing the printer to use the
hard disk to supplement RAM when necessary.
2 Turn the printer off and then on again to make this change take effect.
51/%678%
"
»Note: If a Jaz drive is formatted and the user wants to back up immediately after that,
the printer needs to be taken online first after the format before a backup can be
performed.
Attach the Jaz or Zip drive to which you’ll be backing up data to the printer’s SCSI port
or SCSI chain.
»Note:
You cannot back up data to an internal or external hard disk.
Access the Administration/Disk Operations menu, and then press the control panel
keys in the order shown in the following table. The printer responds by displaying a
status message in the message window (DSK refers to the device, and
# is the device
number).
»Note:
You may need to press the Next key one or more times to advance through the
list of selections or options.
Press this
key...
to... and the message window
reads...
Next Advance to the Disk Operations/Backup Hard
Disk menu
DISK OPERATIONS
BACKUP HARD DISK
Select Access the Backup Hard Disk/Dsk#: menu.
BACKUP HARD DISK
DSK
#x
Next or
Previous
Advance through the list of attached devices.
BACKUP HARD DISK
DSK
#x
Select Access the DSK# x /Full menu.
DSK#
x
FULL
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]