Setup guide

'&%
$#+ 
4 If you need to remove a hard disk before installing one, remove it as follows;
otherwise skip to step 5.
a Place your left hand on the metal interface plate, the thumb on your right hand
on top of the hard disk, and the other fingers on your right hand underneath
the corner of the hard disk, and then pull up gently but firmly on the hard disk.
The disk is firmly seated, so it may take several tries to remove it.
b Unplug the ribbon cable connector from its mating connector on the controller
board.
 Caution: Don’t push or pull with the ribbon cable. Use the cable connector.
...................................................
...................................................
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]