Setup guide

#,*
'()*)% 
 If your PC and printer are connected through the serial port, type
copy /b *.ps com
# ↵
where
# is 1 to 4. (/b refers to binary files.)
5 When the downloading is complete, reboot the printer.
')("
»Note:
Before you begin this procedure, your printer and PC (or UNIX workstation)
must be connected to an Ethernet network running TCP/IP and have valid IP
addresses.
1 If your PC is running Windows, change to DOS.
2 Insert the fonts disk in your PC’s 3.5" disk drive, and change to that drive
(for example, if you’re using the A drive, type a:↵).
3 If you want to download the fonts from a UNIX workstation, copy the instal-
lation file from the fonts disk to a temporary directory on your UNIX work-
station.
4 Turn on the printer, and wait for IDLE to appear in the message window.
5 Open an ftp session at your PC or workstation by typing one of the following
commands:
ftp
printername ↵ (for example, ftp pctdev6↵)
ftp
ipaddress ↵ (for example, ftp 161.33.130.45↵)
6 When prompted for a user name and password, press Enter for both.
An ftp> prompt displays.
7 At the ftp> prompt, change to binary mode by typing
bin↵
8 At the ftp> prompt, send the fonts file to the printer’s hard disk by
typing
put
filename .ps↵
where
filename is the name of the installation file.
The printer’s message window reads 1 Active Job to indicate that the fonts are
being downloaded to the hard disk. The ftp> prompt returns when the fonts have
finished loading.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]