Setup guide

'(

4 When downloading is complete, reboot the printer.
The emulation should be listed in the Options section of the printer’s startup page,
in the Administration/Emulation printer’s configuration menu, and on the advanced
status page.
')("
»Note:
Before you begin this procedure, your printer and PC (or UNIX workstation)
must be connected to an Ethernet network running TCP/IP and have valid IP
addresses.
1 If your PC is running Windows, change to DOS.
2 Insert the emulation disk in your PC’s 3.5" disk drive, and change to that
drive (for example, if you’re using the A drive, type a:↵).
3 If you want to download the emulation from a UNIX workstation, copy the
installation file from the emulation disk to a temporary directory on your
UNIX workstation.
4 Turn on the printer, and wait for IDLE to appear in the message window.
5 Open an ftp session at your PC or workstation by typing one of the following
commands:
ftp
printername ↵ (for example, ftp pctdev6↵)
ftp
ipaddress ↵ (for example, ftp 161.33.130.45↵)
6 When prompted for a user name and password, press Enter for both.
An ftp> prompt displays.
7 At the ftp> prompt, change to binary mode by typing
bin↵
8 At the ftp> prompt, send the emulation file to the printer’s hard disk by
typing
put
filename .ps↵
where
filename is the name of the installation file.
The printer’s message window reads 1 Active Job to indicate that the emula-
tion is being downloaded to the hard disk. The ftp> prompt returns when the
emulation has finished loading.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]