Setup guide
"& %
4 Reinstall the controller board.
Gently slide the controller board into the printer until it is fully seated, and then
tighten the two screws.
5 Reconnect all interface cables.
6 Reconnect the power cord and turn on the printer.
»Note:
In compliance with UL guidelines, “The appliance inlet is considered to be
the main disconnect device.”
7 Print a startup page.
The time-of-day clock is not listed under “Installed Options” on the startup page,
but the time will appear as System Date in the Printer Information column.
a Locate the time-of-day clock
socket on the controller
board and the pin 1 notch or
printed label.
b Locate the pin 1 indicator
mark on the top of the
time-of-day clock.
This mark may be a notch
or a slight depression on
one end of the clock.
c Align this indicator mark with the pin 1 notch or printed label on the controller
board.
d Gently press down on the time-of-day clock until it’s firmly seated.
◆ Caution:
Make sure that the pins on the time-of-day clock are properly
aligned with those in the receiving socket on the controller board. Damage to
the time-of-day clock and/or controller board could result if the pins are
misaligned.
...................................................
...................................................
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500