Setup guide
"& %
"
c Insert the SCSI interface card connector into its opening in the interface
panel.
d Secure the SCSI interface card to the interface panel with the two larger
screws in the kit.
6 Reinstall the controller board.
Gently slide the controller board into the printer until it’s fully seated, and then
tighten the two screws.
7 Reconnect all interface cables.
8 Reconnect the power cord and turn on the printer.
»Note:
In compliance with UL guidelines, “The appliance inlet is considered to be
the main disconnect device.”
9 Print a startup page.
Check that the startup page lists the interface (SCSI) just installed under
“Options.”
""
»Note:
Installing the SCSI interface kit alone will not allow you to print via SCSI. See
chapter 5, “Storage Devices” for further information about attaching Jaz or Zip drives.
*--(1
The time-of-day clock provides time and date information on the startup page and in
the accounting data.
The optional time-of-day clock kit includes only the following:
Time-of-day clock
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500