Setup guide

"
#$%& !
5 Attach the SCSI interface card to the controller board.
a Position the SCSI interface card so that its ribbon cable connector aligns with
the SCSI connector on the controller board.
b Gently press the ribbon cable connector down until it’s fully seated.
◆ Caution: Make sure that the connectors on the ribbon cable and the controller
board are properly aligned. Damage to the controller board could result if the
pins are misaligned.
3 Remove the two screws holding the metal plate over the
SCSI interface opening.
The SCSI interface opening is labelled “SCSI.” It’s located
next to the “Serial” and “Key” ports.
You can discard the metal plate and screws.
4 Attach the ribbon cable to its connector on the SCSI
interface card.
...................................................
...................................................
..................
...................
..................
...................
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]