Setup guide

$#%
%"
#$%& 
3 Remove the two screws holding the metal plate over the
optional interface opening.
The optional interface opening is labelled “Option.” It’s located
next to the “Parallel” port. Save the two screws. (You’ll use
them when you install the optional interface card.) You can
discard the plate.
4 Attach the interface card to the controller board.
a Position the interface card so that its I/O connector slides
into its opening in the interface panel and that its 80-pin
connector aligns with the 80-pin connector on the
controller board.
b Gently press the interface card down until its connector is
fully seated and the card is secured by the plastic support
post(s).
◆ Caution: Make sure that the connectors on the interface
card and controller board are properly aligned. Damage to
the interface card and/or controller board could result if
the pins are misaligned.
...................................................
...................................................
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]