Setup guide

$#%
%"


 Caution: It’s very important to protect the printer controller board and any associated
circuit boards from electrostatic damage. Before performing this procedure, review the
antistatic caution in “Antistatic Protection” on page 3-2. In addition, always handle
circuit boards by the edges only.
1 Turn off the printer, and then
disconnect the power cord
and all interface cables from
the printer.
»Note:
The illustration shows the
printer without the duplexer.
However, the instructions are
the same for all models.
2 Loosen two screws (one on
each end of the interface
panel) and, using the tab on
the lower side of the panel,
pull the controller board from
the printer.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]