Specifications

Parallel Communication
4-11Communications Menu
new setting does not conflict with the PS Wait Timeout and Emul Tim-
eout values.
If the Spool Timeout value expires before the printer has received all
data for a job it is spooling, the printer terminates the spooled print
job. You must turn the printer off and then on again before this change
takes effect.
Data Bits
The Data Bits option sets the number of data bits per character in the
data stream from the host. The choices are 7 and 8 bits. The default
value is 8 bits. Set this value to match the number of data bits trans-
mitted by your host.You must turn the printer off and then on again
before this change takes effect.
End Job Mode
This option enables or disables data stream sensing for end-of-docu-
ment (EOD) terminator strings. These sequences allow hosts to
enforce print job sequencing without considerations for interacting
timeouts. The options are: None (the printer recognizes only the lan-
guage specific terminator commands such as the PostScript ^D com-
mand), QMS EOD (%%EndOfDocument), and HP EOD (<ESC>%-
12345X). Only one form of EOD may be used at a time. The default is
QMS EOD. This change takes effect immediately.
See the QMS Crown Network Notes manual that came with you
printer, for more information on End Job Mode.
PS Protocol
The PS Protocol option sets the binary communications protocol
(BCP) for communicating over a parallel interface to a PostScript
printer. The choices are normal, normal fixed, binary, binary fixed.
The default value is normal. This change takes effect immediately.