Specifications

Serial Communication
4-7Communications Menu
Baud Rate
The Baud Rate option sets the data transmission rate used by the
host over the serial channel. The baud rates are 19200, 38400, 300,
600, 1200, 2400, and 4800. The default value is 9600. Set this option
to match the baud rate used by your host. You must turn the printer off
and then on again before this change takes effect.
 1RW H %DXG  UDW H V   DQG UH TXLUH 57 6&7 6
S
UR WRF RO
Parity
The Parity option allows you to choose the type of parity checking
performed by the host. Parity acts as a check bit to identify data trans-
mission errors. The options are None, Mark, Space, Odd, and Even.
The default value is None. Set this option to match the parity used by
your host. You must turn the printer off and then on again before this
change takes effect.
Ignore Parity
The Ignore Parity options are On and Off; the default is Off. You must
turn the printer off and then on again before this change takes effect.
RCV SW Flow Ctl
If your host uses software flow control, the RCV SW Flow Ctl option
allows you to choose the type of flow control used by the printer for its
communication with the host. The choices are None, XON/XOFF, and
ETX/ACK. The default value is XON/XOFF. Set this option to match
the type of flow control expected by your host. You must turn the
printer off and then on again before this change takes effect.
XMIT SW Flow Ctl
If your host uses software flow control, the XMIT SW Flow Ctl option
allows you to choose the type of flow control used by the host for its
communication with the printer. The choices are None, XON/XOFF,
and ETX/ACK. The default value is None. Set this option to match the