Specifications

Serial
Communication
QMS 4525 Print System Administrator's Guide4-4
then the system generates an end of file to terminate the job and the
next job in the queue begins.The range is 0 to 99999 seconds, and
the default value is 0 seconds (no timeout).
ESP Timeout
The ESP timeout option sets the maximum number of seconds for the
printer to attempt an emulation selection using the Emulation Sensing
Processor. If ESP cannot select an emulation before this time expires,
the printer uses the default emulation to process the job (see chapter
5, “Emulations Menu”). The range is 0 to 99999 seconds, and the
default value is 00003 seconds. A value of 0 disables the timeout.
This option only applies to jobs received through the parallel and
serial interfaces.
Do not set the ESP Timeout to 0 seconds unless you are using the
PostScript interactive mode (see the Mode option in the following sec-
tion, “Serial Communication”).
Serial Communication
The Serial menu controls the default settings for the serial communi-
cation interface values used for printer-host communications.
Communications / Serial Menu
Mode
Emulation
Min K Spool
Spool Timeout
End Job Mode
Baud Rate
Parity
Ignore Parity
RCV SW Flow Ctl
XMIT SW Flow Ctl
Data Bits