Specifications

The Installation

3-27Operator Control and Installation Menus

Procedure

The floppy disk drive is located on the left side of the printer. Support

for the password disk is only available through the control panel. To

install the password disk from the control panel, use the following pro-

cedure:

1 Make sure the printer is off line. The Off indicator light

should be On.

2 With the label facing up, insert the password disk in the

floppy drive.

3 Press the Back key and the main menu appears after the

Password disk has been accessed (this may take about 30

seconds). Press the Next key until the message window dis-

plays

CONFIGURATION INSTALLATION

4 Press the Enter key. To view the options press the Next key.

The options are Operator Passwrd, Use Operator Pwd,

Admin Password, and Use Admin Pwd.

5 Operator Control Menu Password

To set a password for the Operator Control menu use the Opera-

tor Passwrd option to enter the password. Then set the Use Oper-

ator Pwd option to On to enable the password.

Administration Menu Password

To set a password for the Administration menu, use the Admin

Password option to enter the password. Then set the Use Admin

Pwd option to On to enable the password.

6 When the passwords are enabled, return to the Main menu.

From the control panel press the Back key. Save the changes by

selecting Yes. Remove the password disk from the floppy drive,

and put the printer back on line. After you exit from the menu and

take out the disk, the Installation menu is removed from the con-

trol panel message window.