Specifications

Installing Print
System Software
1-13Introduction
9 When BootROM is done with the diskette, it prompts for the
next diskette by displaying
Install to Disk Next Diskette
To continue, place the next diskette in the disk drive and press the
Enter key. This process continues until all the diskettes have been
loaded. Remember, press the Enter key after inserting each dis-
kette.
10 You have now completed installing the system software and
are ready to boot the system.
After the contents of all the diskettes have been loaded, press the
Back key. The message window displays the following message:
QMS Softload x.x Install To Disk
11 Press the Previous or Next key until the message window
displays:
QMS Softload x.x Boot System
12 Press the Enter key, and then press the Previous or Next to
display
Boot System Hard Disk
13 Press the Enter key and the following displays:
Boot System Hard Disk 6
14 Assume that hard disk 6 is the print system's internal hard
disk. If you have any external hard disks connected, you can
cycle through them by pressing the Next key. For this exam-
ple we are using the internal hard disk. Press the Enter key.
The system begins loading, and the following message dis-
plays:
Boot System booting /
15 At this point, DO NOT TOUCH ANY KEYS until the system
has completed loading. The slash bar on the right end keeps
rotating until the download is completed. As soon as down-
loading is done, the BootROM give the CPU to the down-
loaded image immediately. When the system rebooting and