Specifications

Installing Print
System Software
1-11Introduction
 Interface
Current configurations of the standard and optional interfaces.
 Release
Printer firmware release date.
Enabling/Disabling the Start-up Page
To enable printing of the start-up page each time the printer is turned
on, set the Do Start Page option in the Administration/Startup Options
menu to Yes. To disable the start-up page, set the option to No. The
factory default setting is Yes.
Installing Print System Software
Occasionally, you may need to reinstall the printer system software for
your QMS 4525 Print System or to install a software upgrade. Print
system software for your printer is supplied on eight 3.5" 1.44 MB dis-
kettes.
Installing system software requires copying the contents of the disks
to the printer's internal hard disk. You load the software through the
control panel, or through the parallel or LocalTalk port using PS Exec-
utive Series Utilities (see the utilities on-line help for details). The con-
trol panel loading procedure is explained in the next section.
Installing from the Control Panel
To install system software from the control panel, you need to access
the BootROM User menu and perform the following steps:
1 Turn the system off and back on again. The following mes-
sage displays in the message window:
QMS Softload x.x Ready to boot
2 Once this message displays, you have 10 seconds to press
any key.