Specifications

Introduction
QMS 4525 Print System Administrator's GuideE-2
Introduction
This appendix provides updated information on the DOC commands
or PostScript operators that are supported on your QMS 4525 Print
System (with the optional stacker/stapler), but are usually docu-
mented in other QMS manuals. This information will be merged into
the QMS manuals listed in this section, as they are revised. But until
then, the information in this appendix supersedes the following infor-
mation in the QMS Crown Document Option Command manual (part
number 1800216-001E).
The following sections of this manual are affected:
 Chapter 5 “Sessions”
 Border command
 Staple command
 Offset stacking command
 Line Printer Emulation lporientation command
 PCL 4 Emulation reset and resource commands
 All PCL 5 Emulation commands
The information in this appendix should be used in conjunction with
the following QMS documents:
 QMS Crown Technical Reference Manual digital (part number
1810001-001A)
 QMS Crown Document Option Commands manual (part number
1800216-001E)
Hardware Requirements
This appendix provides information on the stapling and offset stack-
ing/jogging commands for the QMS 4525 Print System. However, the
optional stacker/stapler unit is required to support these commands. If