Specifications

About this Manual
1-3Introduction
 Chapter 6 - Special Pages and Startup Options Menus
Describes the Special Pages Header, Error, and Trailer Pages
options that you use to turn header and/or trailer page printing on
and off, to describe the input bins to print these pages from, and
to explain whether to print timing messages on the error page.
Special Pages also allows you to select the status page type.
Startup Options describes the Do Start Page, Do Sys Start, and
Do Error Handler options.
 Chapter 7 - Memory Menu
Explains memory management and describes the Memory
menus that you use to set the default sizes of the following mem-
ory clients: spool buffer, PS heap, PS fonts, emulations, emula-
tions temporary space, disk cache, and printer memory.
 Chapter 8 - Engine, Miscellaneous, and Disk Operations
Menus
Explains how to use the Engine menu to set up default laser
intensity, test page, image alignment, input bin names, low toner
action, manual feed timeout, gamma correction, sorter setup, and
finisher setup (if installed). It also explains how to use the Miscel-
laneous menu to restore the printer to factory default settings, set
the printer name for a console system, set the control panel lan-
guage, and set clock operations. The Disk Operations menu
allows you to perform file operations using the printer 's hard
disks.
 Chapter 9 - Using the Sorter
Describes how to use the 20-bin and 40-bin sorters.
 Chapter 10 - Using the Stacker/Stapler
Describes how to setup and use the stacker/stapler, and how to
use offset stacking.
 Chapter 11 - Printer-Host Connection
Briefly explains your printer's Simultaneous Interface Operation
(SIO) and Emulation Sensing Processor (ESP) technology. Then
the chapter describes how to connect a host to the printer's