Specifications

Disk Operations
Menu
8-17Engine, Miscellaneous, and Disk Operations Menus
8 When the contents of the hard disk have been backed up, the
message
BACKUP COMPLETE
displays. Press the Back key to return to the Backup Hard
Disk selection. Press the Line key to ready the printer for
receiving data from the host.
Restoring the Hard Disk
Use your back-up disks to restore the contents of the hard disk in the
event of a hard disk failure.
1 To restore a hard disk, place the printer off line and use the
control panel to access Disk Operations. The
ADMINISTRATION DISK OPERATIONS
message display.
2 Open the side panel (see the illustration in the section on
“Installing an Option” above) to access the floppy disk drive.
3 Press the Enter key to enter the Disk Operations menu.
Press the Next key until
RESTORE HARD DISK
displays in the second field of the message display.
4 Press the Enter key again. Press the Next key until the
address of the hard disk that you want to restore displays in
the second field of the message display (for example, DSK6).
5 Press the Enter key. The display prompts you to insert a
floppy disk (your back-up disk) in the floppy disk drive.
 1RWH <R XPXV WLQV HUWWK HEDFNX
S
GLVNVLQVHTXHQFH, I\R X LQVHUWD
GLVNRXWRI VHTX HQFHWKHPHVVDJH
SEQUENTIAL ERROR
GLV
S
OD\V5HPRYHWKH GLVNDQGLQ VHUWWKHFRUUHFWRQHWRFRQWLQXH