Specifications

Disk Operations
Menu
8-13Engine, Miscellaneous, and Disk Operations Menus
7 The message
READING DATA
displays until the contents of the disk have been copied to
the hard disk. When the copy process finishes, the message
INSTALL COMPLETE
displays. Press the Back key to return to Install Option.
8 Press the Line key to ready the printer for receiving data
from the host.
Removing an Option
Use Remove Option if you need to remove an installed option from
the printer's hard disk. To remove an option, you need the original
3.5" disk containing the option files. (The Remove Option compares
the contents of the disk with the contents of the hard disk. Matching
files are then deleted from the hard disk.)
1 To remove an option, place the printer off line and use the
control panel to display
ADMINISTRATION DISK OPERATIONS
in the message display.
2 Open the side panel to access the floppy disk drive. (See the
illustration in the “Installing an Option” section above.)
3 Press the Enter key to enter the Disk Operations menu.
Press the Next key until
REMOVE OPTION
displays in the second field of the message display.
4 Press the Enter key again to select Remove Option. Press
the Next key until the address of the hard disk containing the
option displays in the second field of the message display.
5 Press the Select key to select the option's disk address. The
display prompts you to insert a disk (the disk containing the
original option) in the floppy disk drive.