Specifications

Engine Setup Menu

8-3Engine, Miscellaneous, and Disk Operations Menus

The range of possible values for Laser Intensity is 0 to 56. The default

value is 30. Use the following procedure to reset the laser beam inten-

sity.

1 From the Engine Setup menu, select the Laser Intensity

option.

2 Select Intensity. The current intensity setting displays

LASER INTENSITY (0-56) ENTER VALUE [

in which

is the current setting.

3 Enter the new setting on control panel.

4 Press the Enter key to select the new setting.

5 Print a test page by selecting Test Page from the Laser Inten-

sity menu. The range of possible values are none, simplex,

and duplex. The default value is none.

None Does not print a test page.

Simplex Prints a test page on one side of the page.

Duplex Prints a test page on both sides of the page.

 1RWH:KLOH\ RXDUH

ULQWLQJDWHVW

DJHP HVVDJH GLV

OD\VDUHQRW

DIIHFWHG

On the test page are a horizontal bar of gray-scale boxes num-

bered 1 through 10, and a vertical bar of gray-scale boxes identi-

fied by A through J. The gray-scale boxes next to 1 and A should

be barely visible, and there should be a difference in shading

between boxes 9 and 10, and between boxes I and J.

6 If the test page is too light (one or more boxes are blank), go

back to step 3 and set Laser Intensity to a lower value. If the

test page is too dark (if you can make no distinction between

boxes I and J or 9 and 10), go back to step 3 and increase the

laser beam intensity setting to a higher value.