User`s guide

The RESET Command
You should remember that any command change you make within
a control code remains in effect until you change it, that is, the
printer “defaults” to your change when it powers up. In order for
the printer to default to the settings listed in Table 12.1, you may
enter a RESET command. If you enter the RESET command of
<esc><E> to the beginning of each new command change, your
printer performs the commands for change, but returns to the
default settings when it completes the job.
NOTE: The tables displaying escape sequence command are
printed in Helvetica font. This font was chosen to best
show the difference of the lowercase letter l and the
numeral 1. Also the uppercase letter O is rounder than the
numeral 0.
Chapter 11
HP LaserJet series II Emulation 11-7