Specifications

!

)
$"##
#$"
!"!
1 In the Operator Control/Media/For MPT Tray select Thick
Stock.
2 In the Operator Control/Outputbin menu select Face-Up.
3 Open the flaps.

Caution:
Do not seal
envelopes before printing.
4 Flex the envelope stack (including the edges) to remove any
stiffness.
Tape must not be present on the adhesive part of the envelope.
5 Place the envelopes on a flat surface, and flatten them by
pressing down the corners.
6 Adjust the multipurpose tray
media guide to the width of
the envelopes.
7 Separate each envelope immediately (before it cools) after
the envelope is delivered to the face-up tray.
»Note:
Because the envelopes pass through heated rollers, the
gummed area on the flaps may seal to other flaps in the tray
otherwise. Using envelopes with emulsion-based glue avoids this
problem.
