Setup guide
.1
)*
2 Insert the copy key in the “Key” port on the printer’s inter-
face panel.
Caution:
Even though both the copy key and serial interface
have a DB-9 interface, the connectors are keyed, and they can’t
be interchanged. Make sure that you install the copy key only in
the port marked “Key.”
3 When the scanner is ready, make sure that no documents are
on the scanner glass, and then prepare the ADF.
4 Move the paper feed guides on the ADF so that they’re
approximately 0.25"/5 mm wider than the document.
5 Place the document to be copied face down in the input
paper chute, putting the ends of the bottom 2 or 3 sheets
into the automatic feeder.
Slide the stack forward until it rests against the ADF sensor. The
sensor is a small plastic arm inside the ADF. The ADF can be
loaded with up to 50 sheets of A4-, legal-, or letter-size paper.
You might have problems using thick stock in the ADF.
Caution:
Do not feed any of the following through the ADF:
Paper with clips or staples
Paper with wet ink
Paper with folds, tears, notches, or curls
Paper with an inconsistent thickness, such as envelopes
Very thin paper
Paper not square or rectangular in shape
Paper smaller than A5 size or larger than A4 width
Tracing, coating, carbonless, or photographic paper
Items other than paper, such as transparencies, metal
sheets, or cloth
Important documents that must not be damaged
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500