Setup guide

.1
))%#
»Note: While you can scan and print multiple copies of single-sheet
documents without a hard disk, a hard disk is required to print
multiple copies of multiple-sheet documents (with or without collation)
from the automatic document feeder (ADF).
The printer’s hard disk is used for temporary storage of the scanned
image. There must be enough free space on the hard disk (at least 15
MB) to store the largest-size scanned image. The size of this image
depends on the paper size and the printer resolution.
This section identifies the amount of Display List memory required to
print multiple copies of multiple sheets (with or without collation) from
the ADF.
1 Enable disk swapping (Administration/Memory/Enable Disk
Swap menu).
2 Increase the Display List memory by 60 MB/60,000 KB
(Administration/Memory/Manual Config/K Mem Display
menu).
The printer automatically reboots when you press the Online key.
3 Choose collation, if necessary.
4 Begin the copying/scanning procedure (Copy key).
5 If the printed output is not correctly collated, use the
Administrator/Memory/Manual Config/K Mem Display menu
to increase the Display List memory in 10 MB (10,000 KB)
increments until the output is correctly printed.
For complete information on this option, refer to chapters 4 and 5
in the
Reference manual.

1 Turn on the scanner, wait 5 seconds, and turn on the printer.


 Caution: The scanner must be turned on first so the printer can
recognize the scanner’s presence.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]