Setup guide


)%#

1 Refer to the instructions that come with the scanner to
unpack it and prepare it for use.
2 Ensure that the scanner’s SCSI ID is set to 5.
3 Locate the SCSI connector on the rear of the scanner.
4 If you’re connecting only the scanner to the printer, use the
following procedure. Otherwise, go to step 5.
a Plug the male end of the SCSI terminator into the scanner’s
SCSI connector.
b Attach one end of the SCSI cable to the terminator and the
other end of the cable to the printer.
c Go to step 6.
5 If you’re connecting the scanner and one or more external
SCSI devices to the printer, use the following procedure:
a Plug the daisy chain connector into the scanner.
b Attach one end of the SCSI cable to the daisy chain
connector and the other end of the cable to the SCSI port on
the printer.
c Attach one end of another SCSI cable to the daisy chain
connector.
!
"!#$%
!!&
'#
!!
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]