Setup guide
8::87!
'
4114/(
5 To test the BuzzBox Lite, make sure its switches are on, then
press the printer’s Online key to take the printer off line.
»Note:
You can use the BuzzBox switches to enable or disable the
buzzer, the light, or both.
When the printer goes off line, the light flashes and the buzzer
sounds until the printer is placed back on line or until the light and
buzzer switches are turned off.
1 Attach one end of the RJ-11 cable connector
to the port labeled “BuzzBox.”
2 Attach the other end of the RJ-11 cable to the
BuzzBox Lite unit.
3 Choose a location to mount the BuzzBox Lite
unit.
Ensure that the unit does not
interfere with media exiting the printer.
cover any vents, doors, connectors, or
labels.
cause the BuzzBox ribbon cable to stretch or
twist.
4 Use the adhesive-backed clips provided to
mount the BuzzBox Lite unit where the
printer operator can see and/or hear it.
We’ve provided a cable, but you can use up to a
500-foot cable (RJ-11 4-pin or 6-pin).
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500