Setup guide

/7
 
.
&) .
+"
»Note: You must have an optional SCSI interface board installed
before you can attach an external SCSI hard disk, Jaz drive, or Zip
drive. Refer to the installation instructions in chapter 3 “Interfaces and
Daughterboards.”
,/
For information on attaching an external SCSI hard disk, an Iomega
Jaz drive, or an Iomega Zip drive, see the documentation that comes
with the device. You may also contact QMS Technical Support or visit
QMS via the Internet at www.qms.com/support.
10 Align the support posts with the holes on the controller
board, and then press down to secure the hard disk to the
controller board.
So that you don’t stress the board, press one corner at a time to
secure the hard disk to the controller board.
11 Reinstall the controller board panel on the printer.
12 Tighten the two screws.
13 Push the fuser unit back in.
14 Close the printer’s front cover.
15 Reconnect all interface cables.
16 Reconnect the power cord and turn on the printer.
»Note:
In compliance with UL guidelines, “The appliance inlet is
considered to be the main disconnect device.”
17 Print a startup page.
Check that the startup page indicates the presence of the
hard disk.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]